village-hall
016 High-School2
village-musuem047
village-musuem049
village-museum037
slider-school
2020 VOM police
village-williams143 2
046 The-Old-Mill
Senior-Center
village-musuem048
slider-gmd
slider-church
053 View-of-Union-Street
village143
slider-clinton-st
054 Wallkill-Ave---church
slider-car-show
026 Montgomery-High-School
029 Municipal-Building-firemen-museum
slider-ff-museum
028 Municipal-and-Fire-Department-Building
village museum001b
slider-ss
007 Clinton-Street3
village museum009
slider-village-museum
slider-houses
011 Community-House-showing-school-in-distance
014 Fire-Headquarters
030 Old-Firemens-Hall
019 Methodist-Church-2
slider-post-office
015 High-School
village museum026
033 Presbyterian-Church---Montgomery-Acedemy-3
slider-red-school
village museum027
035 Presbyterian-Church-Park-and-Band-Stand
village museum028
037 RC-Church-2
village-musuem058
002 Business-Section
003 Clinton-and-Union
004 Clinton-Street-Looking-West
005 Clinton-Street
024 Montgomery-Bridge-across-the-Wallkill-River
20 Fire-at-Montgomery-Academy
006 Clinton-Street2
99 Wallkill-River-Dam-at-Montgomery,-NY
MontgomeryBicentennialLogo_angled
Located in the beautiful Hudson Valley, the Village of Montgomery is a great place to live, raise a family, shop, and do business.

Annual Drinking Water Quality Report for 2021
Village of Montgomery Water System
133 Clinton Street, Montgomery, NY
(Federal ID 3503542)

Testing of our water supply system is done to be sure the drinking water that the Village of Montgomery delivers to your home or business remains safe.

The NYS DOH has completed a source water assessment for this system based on available information.  Possible and actual threats to the drinking water source were evaluated.  The state source water assessment includes a susceptibility rating based on the risk posed by each potential source of contamination and how easily contaminants can move through the subsurface to the wells.  The susceptibility rating is an estimate of the potential for contamination of the source water, it does not mean that the water delivered to consumers is or will become contaminated.  See “Table of Detected Contaminants” for a list of the contaminants that have been detected.  The source water assessments provide resource managers with additional information for protecting source waters into the future.

As mentioned before, our water is derived from seven drilled wells.  The source water assessment has rated these wells as having a medium to high susceptibility to microbials, nitrates, industrial solvents, and other industrial contaminants.  These ratings are due primarily to the close proximity of a SPDES permitted discharge facility (industrial/commercial facilities that discharge wastewater into the environment and are regulated by the state and/federal government), the low-level residential activity and the pasture that is located in the assessment area.  In addition, the wells draw from fractured bedrock and various aquifers and the overlying soils may not provide adequate protection from potential contamination.  While the source water assessment rates our wells as being susceptible to microbials, please note that our water is disinfected to ensure that the finished water delivered into your home meets New York State’s drinking water standards for microbial contamination.  A copy of the assessment, including a map of the assessment area, can be obtained by contacting us, as noted in this report.

To comply with State and Federal regulations, the Village of Montgomery will be annually issuing a report describing the quality of your drinking water.  The purpose of this report is to raise your understanding of drinking water and awareness of the need to protect our drinking water sources.  Last year, your tap water met all state drinking water health standards.  This report provides an overview of last year’s water quality. Included are details about where your water comes from, what it contains, and how it compares to State standards.If you have any questions about this report or concerning your drinking water, please contact Department of  Public Works Superintendent Ralph Nelson at 457‑5321. We want you to be informed about your drinking water.  If you want to learn more, please attend any of our regularly scheduled Village Board meetings. The meetings are held the 1st and 3rd Tuesday of each month at 133 Clinton St., Montgomery, NY.

Where does our water come from?
In general, the sources of drinking water (both tap water and bottled water) include rivers, lakes, streams, ponds, reservoirs, springs, and wells.  As water travels over the surface of the land or through the ground, it dissolves naturally‑occurring minerals and can pick up substances resulting from the presence of animals or from human activities.  Contaminants that may be present in source water include: microbial contaminants; inorganic contaminants; pesticides and herbicides; organic chemical contaminants; and radioactive contaminants.  In order to ensure that tap water is safe to drink, the State and the EPA prescribe regulations which limit the amount of certain contaminants in water provided by public water systems.  The State Health Department's and the FDA's regulations establish limits for contaminants in bottled water which must provide the same protection for public health.

Facts and Figures:
Our water system serves approx. 3,800 people thru approx. 1,400 service connections. The total water produced in 2021 was 92,787,000 gallons.  The daily average of water treated and pumped into the distribution system was 254,000 gallons per day.  Our highest single day was approx. 390,000 gallons. The amount of water delivered to customers was 74,634,000 gallons. This leaves an unaccounted for total of 18,153,000 gallons in 2021.  This water was used to flush mains, fight fires, and was lost to water main breaks. Water customers were charged $3.85 per 1,000 gallons through 49,999 gallons and $4.45 per 1,000 gallons for 50,000 gallons and above. Minimum charge for water is $15.40.

It should be noted that all drinking water, including bottled drinking water, may be reasonably expected to contain at least small amounts of some contaminants.  The presence of contaminants does not necessarily indicate that water poses a health risk.  More information about contaminants and potential health effects can be obtained by calling the EPA's Safe Drinking Water Hotline (800‑426‑4791) or the Orange County Health Department at 291‑2331.

                                           

Are there contaminants in our drinking water?

As the State regulations require, we routinely test your drinking water for numerous contaminants. These contaminants include: total coliform, inorganic compounds, nitrate, nitrite, lead and copper, volatile organic compounds, asbestos and synthetic organic compounds. The table below depicts which compounds were detected in your drinking water. The State allows us to test for some contaminants less than once per year because the concentrations of these contaminants do not change frequently. Some of our data though representative, are more than one year old. Some of the compounds we analyzed for were detected in your drinking water but below Health Dept. standards.

Some people may be more vulnerable to disease causing microorganisms or pathogens in drinking water than the general population.  Immune-compromised persons, such as persons with cancer undergoing chemotherapy, persons who have undergone organ transplants, people with HIV/AIDS or other immune system disorders, some elderly, and infants can be particularly at risk from infections.  These people should seek advice from their health care provider about their drinking water.  EPA/CDC guidelines on appropriate means to lessen the risk of infection by Cryptosporidium, Giardia and other microbial pathogens are available from the Safe Drinking Water Hotline (800-426-4791).

 

 

Copper;

The level presented represents the 90th percentile of the twenty sites tested. A percentile is a value on a scale of 100 that indicates the percent of a distribution that is equal to or below it. The 90th percentile is equal to or greater than 90% of the copper values detected at your water system. In this case, twenty samples were collected at your water system and the 90th percentile value was the third highest sample taken which was .35 mg/l.  The action level for copper was not exceeded at any of the sites tested.

Lead;

The level presented represents the 90th percentile of the twenty sites tested.  A percentile is a value on a scale of 100 that indicates the percent of a distribution that is equal to or below it.  The 90th; percentile is equal to or greater than 90% of the lead values detected at your water system.  In this case, twenty samples were collected at your water system and the 90th percentile value was of the third highest sample taken which was 12 ug/l. The action level for lead was exceeded at two of our test sites. If present, elevated levels of lead can cause serious health problems, especially for pregnant women, infants, and young children. It is possible that lead levels at your home may be higher than at other homes in the community as a result of materials used in your home’s plumbing. The Village of Montgomery is responsible for providing high quality drinking water but cannot control the variety of materials used in plumbing components. When your water has been sitting for several hours, you can minimize the potential for lead exposure by flushing your tap for 30 seconds to 2 minutes before using water for drinking or cooking. If you are concerned about lead in your water, you may wish to have your water tested. Information on lead in drinking water, testing methods, and steps you can take to minimize exposure is available from the Safe Drinking Water Hotline (1-800-426-4791) or at http://www.epa.gov/safewater/lead.

Below is a table of detected contaminants.

Maximum Residual Disinfectant Level (MDRL) : The highest level of a disinfectant allowed in drinking water. There is convincing evidence that addition of a disinfectant is necessary for control of microbial contaminants.
Maximum Residual Disinfectant Level Goal (MRDLG): The level of a drinking water disinfectant below which there is no known or expected risk. MRDLGs do not reflect the benefits of the use of disinfectants to control microbial contamination.
Maximum Contaminant Level (MCL): The highest level of a contaminant that is allowed in drinking water.  MCLs are set as close to the MCLGs as feasible.
Maximum Contaminant Level Goal (MCLG): The level of a contaminant in drinking water below which there is no known or expected risk to health.  MCLGs allow for a margin of safety.
Action Level (AL): The concentration of a contaminant which, if exceeded, triggers treatment or other requirements which a water system must follow.
Non-Detects (ND): Laboratory analysis indicated that the constituent is not present.
Milligrams per liter (mg/l): Corresponds to one part of liquid in one million parts of liquid (parts per        million - ppm).
Micrograms per liter (ug/l): Corresponds to one part of liquid in one billion parts of liquid (parts per billion - ppb).
Nanograms per liter (ng/l): Corresponds to one part of liquid to one trillion parts of liquid (parts per trillion - ppt

 

Table of Detected Contaminants

Contaminant

Violation Yes/No

Date Of Sample

Level Detected

Unit of Measure

MCLG

Regulatory Limit (MCL-TT or AL)

Likely Source of Contamination

Lead

No

June/July/ August 2019

90th =  12

ug/l

0

AL = 15

Corrosion of household plumbing systems

Range = 1 - 26

Copper

No

June/July/ August 2019

90th = 0.35

mg/l

1.3

AL = 1.3

Corrosion of household plumbing systems

Range = .040 - .710

Nitrate

No

June 2, 2021

average = 1.49

mg/l

10 mg/l

10 mg/l

Run-off from fertilizer use

range= 0.58 – 3.2

Total Trihalomethanes

No

August 19, 2021

59

ug/l

N/A

80 ug/l

By-product of drinking water chlorination needed to kill harmful organisms. TTHs are formed when source water contains large amounts organic matter.

Haloacetic Acid

No

August 19, 2021

35.6

ug/l

N/A

60 ug/l

Formed when source water contains large amounts of organic matter

Nickel

No

Sept 7, 2021

Average = 2.57

ug/l

N/A

100

Naturally occuring

Range = 1.9 – 3.9

Barium

No

Sept 7, 2021

Average = 83

ug/l

2,000

2,000

Naturally occuring

Range = 30-150

Sodium

No

July 15, 2021

Average = 60

mg/L

N/A

See Note 1

Road Salt

Range = 29 - 80

Perflurooctanoic Acid (PFOA)

No

Jan, Mar, Jun
Sept 2021

Average = 1.23

ng/l

N/A

10

released into the environment from widespread use in commercial and industrial applications

Range = ND – 3.11

See Note 2

Perfluorooctane sulfonic acid (PFOS)

No

Jan, Mar, Jun
Sept 2021

Average = 0.67

ng/l

N/A

10

released into the environment from widespread use in commercial and industrial applications

Range = ND – 1.31

     See Note 2

Note 1: Water containing more than 20 mg/l of sodium should not be used for drinking by people on severely restricted sodium diets. 

Water containing more than 270 mg/l of sodium should not be used for drinking by people on moderately restricted diets.

Note 2:  Please note that in addition to PFOS and PFOA, the lab ran the analysis for the entire EPA method 537.1, which  includes 16 additional perfluorinated chemicals, 3 of these additional chemicals were detected, the highest of Which was 2.06 ng/l.  These additional analytes are not currently regulated and do not have an MCL.

Great Race visits Village of Montgomery